PO1

Development is:

1. ancillary to the primary use, and
2. does not compromise the low density character of the locality.

AO1.1

No more than 1 caretaker's accommodation unit is established on the site.

AO1.2

Development is a maximum of 100m2 GFA.

PO2

Buildings are:

1. low rise
2. low density
3. of a size and scale that ensures the built form does not dominate natural landscape values, and
4. designed and located so as not to adversely impact on the coastal and visual character of the area.

AO2.1

Building height does not:

1. exceed 8.5m and 2 storeys, and
2. protrude above any horizon, ridge or spur line when viewed from any place on the coastline (beach or headlands) or from the ocean.

Note—Refer also to Diagram 6.2.4.3.1—Character dwelling house.

AO2.2

The floor level of the upper most habitable level is no greater than 5.1m above ground level at any point.

Note—Refer also to Diagram 6.2.4.3.1—Character dwelling house.

AO2.3

The floor of the first habitable level including decks and verandahs is no greater than 3m above ground level at any point.

Note—Refer also to Diagram 6.2.4.3.1—Character dwelling house.

AO2.4

The maximum footprint for all buildings including any outbuildings, swimming pools or other structures is:

1. 400m2 on lot sizes 800m2 – 1499m2, or
2. 450m2 on lot sizes 1500m2 – 2499m2, or
3. 500m2 on lots greater than 2500m2.

PO3

Buildings are located on the site to:

1. to maximise the residential amenity of residents and neighbours
2. maximise retention of native vegetation, and
3. provide areas for landscaping to screen the building.

AO3.1

Buildings are setback a minimum of 6m from the front and rear boundaries.

Note—A carport may be built in the 6m front setback where the maximum height is 3.5m.

AO3.2

Side boundary setbacks for any building or structure are a minimum of 4m.

Note—Side boundary setbacks are measured to the building wall.

AO3.3

Where dual occupancy, dwellings are separated by a minimum of 6m.

Note—Buildings can be linked by one unenclosed verandah or walkway.

PO4

Residential density reflects the low density character of the locality.

AO4.1

Residential density is a maximum of

1. 1 Dwelling house (including 1 secondary dwelling) per allotment; or
2. 1 dwelling unit per 400m2 where a Dual occupancy.

AO4.2

Where a dwelling house, any secondary dwelling is:

1. a maximum of 80m2 GFA
2. located within 50m of the main building
3. linked to the main building by a defined footpath in the most direct route possible.

PO5

Buildings reflect the coastal character of the zones through open frame architecture including verandahs/decks, eaves and the use of lightweight construction materials.

AO5.1

Buildings:

1. include suspended floors
2. use sheet material finishes such as timber and fibre cement for external cladding
3. limit masonry construction so that no masonry walls exceed 4.5m above ground level and:
   1. are rendered and painted, or
   2. where constructed of local stone left unfinished; and
   3. incorporate appropriate articulation
4. include roofing comprised of lightweight and non–reflective sheet materials.

AO5.2

Eaves extend a minimum of 0.6m from the wall.

PO6

Front fencing must:

1. not dominate the streetscape, and
2. complement the low density sub–tropical character of the area.

AO6

Front fences are:

1. a maximum height of 1.5m
2. 50% transparent
3. made of open timber or metal construction, and
4. do not impede existing overland flow paths.

PO7

Driveways, cross overs and car parking areas:

1. do not dominate the streetscape
2. are located to minimise the removal of mature trees, and
3. constructed from permeable materials where possible to maintain natural drainage flows and maximise stormwater infiltration on–site.

AO7.1

Driveways, crossovers and car parking areas are:

1. finished with a permeable surface, and
2. not located within 4m of the side boundary.

AO7.2

Driveways and crossovers are:

1. a maximum of 3.5m wide including splays, and
2. limited to 1 per lot.

PO8

Development and landscaping:

1. enhances visual amenity and screen buildings from streets, walkways and other public places
2. integrates with the natural features
3. minimises earthworks and the use of retaining walls, and
4. complements the low density sub–tropical character of the area.

AO8.1

Plant species used for landscaping are native to the locality.

AO8.2

Uncovered external paved or hard landscaped areas not used for car parking are limited to 36m2 where a Dwelling house or 18m2 where a dual occupancy.

AO8.3

Excavation and fill is limited to:

1. maximum cut of 1m below ground level, and
2. maximum fill of 1m above ground level.

AO8.4

Retaining walls and terraces are:

1. not constructed to create a level lot
2. a maximum 0.6m high to the street frontage, and
3. a maximum height of 1.2m elsewhere on the lot.

PO9

Development is of a small scale that does not compromise the low density and coastal village character of the locality.

PO10

Development responds sensitively to on–site and surrounding topography, drainage patterns, utility services, access, vegetation and adjoining land use, such that:

1. any hazards to people or property are avoided
2. native plants are retained within the lot or premises and adjoining road reserve
3. any earthworks are minimised
4. the retention of natural drainage systems is maximised
5. the retention of existing vegetation is maximised
6. damage or disruption to sewerage, stormwater and water infrastructure is avoided, and
7. there is adequate buffering, screening or separation to adjoining development.

PO11

Development maintains a high level of amenity within the site and minimises impacts on surrounding areas, having regard to:

1. noise
2. hours of operation including temporary uses
3. traffic and parking
4. visual impact
5. signage
6. odour and emissions
7. lighting
8. access to sunlight
9. privacy.

Note—Applicants may be required to engage specialists to provide detailed investigations into the above matters in order to demonstrate compliance with this performance criterion.